[Date Prev] | [Thread Prev] | [Thread Next] | [Date Next] -- [Date Index] | [Thread Index] | [List Home]
Subject: AW: [dita] hazard statement widths
You are right, but do we realy try to avoid any possible stupidity done by authors? If someone defines a table width of 2 inches and adds an image into a table cell giving the width of 3 inches? Isn't it the same problem? But on one point you are absolutely right, we should review the note and hazardstatement attributes for DITA Version 1.3. There are a couple of open issues there, e.g. additional attributes to define the panel arrangement of a note or hazardstatement. Paul, I will take you input to our subcommittee and we will discuss what additional attributes are required and which should be removed. For DITA 1.2 we have just copied the attributes from note. But there might be better ideas. Best regards Chris SeicoDyne GmbH Eichenstrasse 16 CH-6015 Reussbühl Switzerland Tel: +41 41 534 66 97 Mob: +41 78 790 66 97 Skype: seicodyne www.seicodyne.com christian.kravogel@seicodyne.com Member of the DITA Technical Committee Chairman of the DITA Machine Industry Subcommittee -----Ursprüngliche Nachricht----- Von: Grosso, Paul [mailto:pgrosso@ptc.com] Gesendet: Dienstag, 10. Februar 2009 16:02 An: dita Betreff: [dita] hazard statement widths In a hazard statement, you can set the width of the hazard statement using the attribute width. There is also an align attribute, so if the set width is smaller than the available width, we could align the output to center, right, or left. So far so good. But then there is also a width attribute on the hazardsymbol tag which is a child of the hazard statement. There is nothing to prevent users from doing things like setting the hazard statement width to 2 inches and the hazard symbol width to 3 inches. It seems either we need to remove one of the width attributes from the DTD or the spec needs to define what the correct processing should be in such cases. paul --------------------------------------------------------------------- To unsubscribe from this mail list, you must leave the OASIS TC that generates this mail. Follow this link to all your TCs in OASIS at: https://www.oasis-open.org/apps/org/workgroup/portal/my_workgroups.php
[Date Prev] | [Thread Prev] | [Thread Next] | [Date Next] -- [Date Index] | [Thread Index] | [List Home]