ws-rx message
[Date Prev]
| [Thread Prev]
| [Thread Next]
| [Date Next]
--
[Date Index]
| [Thread Index]
| [List Home]
Subject: RE: [ws-rx] [NEW ISSUE] Rollover underspecified, state of sequence isunclear
- From: Doug Davis <dug@us.ibm.com>
- To: ws-rx@lists.oasis-open.org
- Date: Mon, 26 Jun 2006 17:14:11 -0400
I have no idea what happened but issue
111 doesn't show up in the change log so, as you noted, it was never applied.
I've now do so - please see the
latest WD and see if we still need your issue.
-Doug
"Bob Freund-Hitachi"
<bob.freund@hitachisoftware.com>
06/26/2006 03:48 PM
|
To
| Doug Davis/Raleigh/IBM@IBMUS, <ws-rx@lists.oasis-open.org>
|
cc
|
|
Subject
| RE: [ws-rx] [NEW ISSUE] Rollover underspecified,
state of sequence is unclear |
|
I think we did, but I can’t
find it in WD 15.
I think that we decided that
it might close the sequence but that is not in the text unless you know
where it is.
Thanks
-bob
From: Doug Davis [mailto:dug@us.ibm.com]
Sent: Monday, June 26, 2006 12:25 PM
To: ws-rx@lists.oasis-open.org
Subject: Re: [ws-rx] [NEW ISSUE] Rollover underspecified, state of
sequence is unclear
Bob,
if a MsgNumRollover fault is generated I don't think the RMD should
necessarily terminate the sequence.There may be other messages, with lower
numbers, that could still be received and processed successfully. Didn't
we discuss this already - it sounds familiar.
-Doug
"Bob Freund-Hitachi"
<bob.freund@hitachisoftware.com>
06/26/2006 11:33 AM
|
To
| "[WS-RX]" <ws-rx@lists.oasis-open.org>
|
cc
|
|
Subject
| [ws-rx] [NEW ISSUE] Rollover underspecified,
state of sequence is unclear |
|
Description
WD 15 lines 564-570 state that if the internal limitation for MessageNumber
is exceeded by either RMS or RMS, then a MessageNumberRollover fault is
generated.
Section 4.5 which describes the fault provides no further information
Justification
Possibility for protocol lockup or non-interoperable behavior
Target: core
Proposal:
Insert after line 570:
Generation or receipt of a MessageNumberRollover fault MUST immediately
terminate the sequence
Insert in section 4.5
Sent by: RMS or RMD
Condition: message numbers for a Sequence have been exhausted
Action upon Generation or receipt: The Sequence is terminated immediately.
[Date Prev]
| [Thread Prev]
| [Thread Next]
| [Date Next]
--
[Date Index]
| [Thread Index]
| [List Home]