[Date Prev] | [Thread Prev] | [Thread Next] | [Date Next] -- [Date Index] | [Thread Index] | [Elist Home]
Subject: RE: [bt-spec] BTP Issue 1 : Format of binding addresses
BTP Issue 1 : Format of binding addresses
Source: Peter Furniss, Choreology
Category: minor technical
Reference: Draft 0.9, line 3460 approx
Summary:
Bindings need to state explicitly the format of the "binding address" component of their addresses - this should be a requirement in the binding proforma. For the SOAP/HTTP bindings, the format is a URL
Binding address format: This section status the format of the “binding address” field of a BTP address for this binding. For many bindings, this will be a URL of some kind; for other bindings it may be some other form.
in SOAP Binding, add paragraph
Binding address format: shall be a URL, of type HTTP.
In SOAP + Attachments binding, add paragraph
Binding address format: as for soap-http-1
In XML representation of Message Set, Addresses, in the informal XML , element btp:binding address, change "carrier specific URI" to "carrier specific address"
(the last item was referred to in Mark Little's message at the end of the discussion thread)
[Date Prev] | [Thread Prev] | [Thread Next] | [Date Next] -- [Date Index] | [Thread Index] | [Elist Home]
Powered by eList eXpress LLC