resolution problem.

Hi, I’m running docbooks under ant. I’m using it to generate pdf files so I have docbook-website-2.6.0, docbook-xsl-1.69.0, and docbook-xml-4.5CR2 downloaded and configured. I’m also using catalog.xml and CatalogManager.properties file so reference file lookups occur locally. I believe I have everything wired together OK. When run under ANT the resulting Table of Contents in the PDF file gets goofed up. Specifically the subsections tabulation/margin is wrong. The Tabs look like. Note: This is a text version of the pdf file and hand needed editing, so if the editing doesn’t look correct, what you should see is that the subsections are left justified while the chapters are indented into the page rather than the other way around.

1. Scope ...............................................................................................................1

Identification ..............................................................................................................1

System Overview ...................................................................................................... 1

Document Overview ................................................................................................ 2

Relationship to Other Plans .................................................................................... 2

2. Referenced Documents .................................................................................. 3

Furthermore I run the same transform through Oxygen 6.1 with the same transform parameters and get the TOC to appear properly.

1. Scope .............................................................................................................................. 1

Identification ................................................................................................................ 1

System Overview ......................................................................................................... 1

Document Overview ................................................................................................... 2

Relationship to Other Plans ....................................................................................... 2

2. Referenced Documents ................................................................................................ 3

I check the intermediate output and found that the GOOD version is outputting to the fo file:

<fo:block id="toc.d0e1.scope" start-indent="24pt">

While the bad one is outputting to the fo file:

<fo:block id="toc.d0e1.scope" margin-left="24pt">

for the same toc section entry in the source document.

Can anyone tell me what I may be doing wrong?

Thanks in advance for any help,

Adam

docbook-apps message