|
Hi,
As you probably noticed, the titlepage spec file
does not let you specify a graphic above the title and a different one below the
title.
You could try bypassing the titlepage spec file
mechanism and create a layout table for your title page:
That should give you direct control of the page,
without having to guess how the spec file mechanism is working (it is a bit of a
black box).
For the wide graphic, you could set the
start-indent and end-indent to negative values to extend the table out to the
page edges. Be sure to include a start-indent="0pt" and end-indent="0pt"
on your fo:table-body if you do that, or your table cells will inherit that
outer start-indent.
----- Original Message -----
Sent: Friday, October 19, 2007 8:46
AM
Subject: [docbook-apps] Cover pages for
print output
Hello all,
My apologies if this has been answered
elsewhere.
Our documents have a custom cover page that has two
graphics: one above title and one below it. After reviewing the DocBook XSL
guide, I was able to figure out how to add a graphic to the top of the page,
but I have yet to figure out how to add a second graphic. Is there a way to do
this? These graphics actually go all the way to the edges of the page—for a
while I thought I could create a single image and use it as a background image
for the cover page, but I haven’t had any luck figuring that out
either.
I’m using FOP to render the PDF output, if that makes any
difference.
Thanks,
Dave
Shevitz Sr. Technical
Writer | d.shevitz@f5.com |
www.f5.com
P. 206
272 5555 |
F. 206 272 5556 | D.
206 272 6104
F5
Networks |
401 Elliott Avenue
West |
Seattle,
Washington
98119
The
World Runs Better with F5
|