[Date Prev] | [Thread Prev] | [Thread Next] | [Date Next] -- [Date Index] | [Thread Index] | [List Home]
Subject: Re: [virtio-comment] VIRTIO Spec feedback
"Michael S. Tsirkin" <mst@redhat.com> writes: > On Wed, Jan 29, 2014 at 05:05:06PM -0800, Arun Subbarao wrote: >> Please consider our feedback on the Virtio spec. >> >> regards, >> Arun. >> >> >> ==================================================================== >> Arun Subbarao e: asubbarao@lnxw.com >> Vice President, Engineering v: 408-979-4610 >> LynuxWorks, Inc. f: 408-979-3945 >> 855 Embedded Way http://www.lynuxworks.com >> San Jose, CA 95138 Open. Reliable. Safe. Secure >> ==================================================================== > > one comment is unclear. > you ask > Any alignment requirements for these three fields? > Whether or not there are any, please state so explicitly. > > This is device independent, as such, it's documented > in 2.4 Virtqueues. There's a table at the end of page 11 > that documents alignment requirements. > Did you just miss this or is something unclear? We should insert a cross reference, since there's been a question. Result below. Thanks, Rusty. diff --git a/content.tex b/content.tex index 2eb0b26..3b1b14f 100644 --- a/content.tex +++ b/content.tex @@ -926,13 +926,13 @@ struct virtio_pci_common_cfg { Note: this is *not* an offset in bytes. See notify_off_multiplier below. \item[queue_desc] - The driver writes the physical address of Descriptor Table here. + The driver writes the physical address of Descriptor Table here. See section \ref{sec:Basic Facilities of a Virtio Device / Virtqueues}. \item[queue_avail] - The driver writes the physical address of Available Ring here. + The driver writes the physical address of Available Ring here. See section \ref{sec:Basic Facilities of a Virtio Device / Virtqueues}. \item[queue_used] - The driver writes the physical address of Used Ring here. + The driver writes the physical address of Used Ring here. See section \ref{sec:Basic Facilities of a Virtio Device / Virtqueues}. \end{description} \subsubsection{ISR status structure layout}\label{sec:Virtio Transport Options / Virtio Over PCI Bus / PCI Device Layout / ISR status structure layout}
[Date Prev] | [Thread Prev] | [Thread Next] | [Date Next] -- [Date Index] | [Thread Index] | [List Home]