[PATCH net-next v10 3/4] virtio_net: Extend virtio to use VF datapath when available

[Sridhar Samudrala <sridhar.samudrala@intel.com>]

This patch enables virtio_net to switch over to a VF datapath when a VF
netdev is present with the same MAC address. It allows live migration
of a VM with a direct attached VF without the need to setup a bond/team
between a VF and virtio net device in the guest.

The hypervisor needs to unplug the VF device from the guest on the source
host and reset the MAC filter of the VF to initiate failover of datapath
to virtio before starting the migration. After the migration is completed,
the destination hypervisor sets the MAC filter on the VF and plugs it back
to the guest to switch over to VF datapath.

It uses the generic failover framework that provides 2 functions to create
and destroy a master failover netdev. When STANDBY feature is enabled, an
additional netdev(failover netdev) is created that acts as a master device
and tracks the state of the 2 lower netdevs. The original virtio_net netdev
is marked as 'standby' netdev and a passthru device with the same MAC is
registered as 'primary' netdev.

This patch is based on the discussion initiated by Jesse on this thread.
https://marc.info/?l=linux-virtualization&m=151189725224231&w=2

Signed-off-by: Sridhar Samudrala <sridhar.samudrala@intel.com>
---
 drivers/net/Kconfig      |  1 +
 drivers/net/virtio_net.c | 38 +++++++++++++++++++++++++++++++++++++-
 2 files changed, 38 insertions(+), 1 deletion(-)

diff --git a/drivers/net/Kconfig b/drivers/net/Kconfig
index a029b27fd002..30e3bb0532e4 100644
--- a/drivers/net/Kconfig
+++ b/drivers/net/Kconfig
@@ -332,6 +332,7 @@ config VETH
 config VIRTIO_NET
 	tristate "Virtio network driver"
 	depends on VIRTIO
+	select NET_FAILOVER
 	---help---
 	  This is the virtual network driver for virtio.  It can be used with
 	  QEMU based VMMs (like KVM or Xen).  Say Y or M.
diff --git a/drivers/net/virtio_net.c b/drivers/net/virtio_net.c
index 213fddc70fd0..e7428d20763c 100644
--- a/drivers/net/virtio_net.c
+++ b/drivers/net/virtio_net.c
@@ -30,8 +30,11 @@
 #include <linux/cpu.h>
 #include <linux/average.h>
 #include <linux/filter.h>
+#include <linux/netdevice.h>
+#include <linux/pci.h>
 #include <net/route.h>
 #include <net/xdp.h>
+#include <net/net_failover.h>
 
 static int napi_weight = NAPI_POLL_WEIGHT;
 module_param(napi_weight, int, 0444);
@@ -210,6 +213,9 @@ struct virtnet_info {
 	u32 speed;
 
 	unsigned long guest_offloads;
+
+	/* failover when STANDBY feature enabled */
+	struct net_failover *failover;
 };
 
 struct padded_vnet_hdr {
@@ -1523,6 +1529,9 @@ static int virtnet_set_mac_address(struct net_device *dev, void *p)
 	struct sockaddr *addr;
 	struct scatterlist sg;
 
+	if (virtio_has_feature(vi->vdev, VIRTIO_NET_F_STANDBY))
+		return -EOPNOTSUPP;
+
 	addr = kmemdup(p, sizeof(*addr), GFP_KERNEL);
 	if (!addr)
 		return -ENOMEM;
@@ -2306,6 +2315,22 @@ static int virtnet_xdp(struct net_device *dev, struct netdev_bpf *xdp)
 	}
 }
 
+static int virtnet_get_phys_port_name(struct net_device *dev, char *buf,
+				      size_t len)
+{
+	struct virtnet_info *vi = netdev_priv(dev);
+	int ret;
+
+	if (!virtio_has_feature(vi->vdev, VIRTIO_NET_F_STANDBY))
+		return -EOPNOTSUPP;
+
+	ret = snprintf(buf, len, "sby");
+	if (ret >= len)
+		return -EOPNOTSUPP;
+
+	return 0;
+}
+
 static const struct net_device_ops virtnet_netdev = {
 	.ndo_open            = virtnet_open,
 	.ndo_stop   	     = virtnet_close,
@@ -2323,6 +2348,7 @@ static const struct net_device_ops virtnet_netdev = {
 	.ndo_xdp_xmit		= virtnet_xdp_xmit,
 	.ndo_xdp_flush		= virtnet_xdp_flush,
 	.ndo_features_check	= passthru_features_check,
+	.ndo_get_phys_port_name	= virtnet_get_phys_port_name,
 };
 
 static void virtnet_config_changed_work(struct work_struct *work)
@@ -2876,10 +2902,16 @@ static int virtnet_probe(struct virtio_device *vdev)
 
 	virtnet_init_settings(dev);
 
+	if (virtio_has_feature(vdev, VIRTIO_NET_F_STANDBY)) {
+		vi->failover = net_failover_create(vi->dev);
+		if (IS_ERR(vi->failover))
+			goto free_vqs;
+	}
+
 	err = register_netdev(dev);
 	if (err) {
 		pr_debug("virtio_net: registering device failed\n");
-		goto free_vqs;
+		goto free_failover;
 	}
 
 	virtio_device_ready(vdev);
@@ -2916,6 +2948,8 @@ static int virtnet_probe(struct virtio_device *vdev)
 	vi->vdev->config->reset(vdev);
 
 	unregister_netdev(dev);
+free_failover:
+	net_failover_destroy(vi->failover);
 free_vqs:
 	cancel_delayed_work_sync(&vi->refill);
 	free_receive_page_frags(vi);
@@ -2950,6 +2984,8 @@ static void virtnet_remove(struct virtio_device *vdev)
 
 	unregister_netdev(vi->dev);
 
+	net_failover_destroy(vi->failover);
+
 	remove_vq_common(vi);
 
 	free_netdev(vi->dev);
-- 
2.14.3