[PATCH] content: document speed, dupex

["Michael S. Tsirkin" <mst@redhat.com>]

Document as used by Linux.

Signed-off-by: Michael S. Tsirkin <mst@redhat.com>
---
 content.tex | 25 +++++++++++++++++++++++++
 1 file changed, 25 insertions(+)

diff --git a/content.tex b/content.tex
index bff80d0..e89ae44 100644
--- a/content.tex
+++ b/content.tex
@@ -2951,12 +2951,29 @@ \subsection{Device configuration layout}\label{sec:Device Types / Network Device
 VIRTIO_NET_F_MTU is set. This field specifies the maximum MTU for the driver to
 use.
 
+The following two fields, \field{speed} and \field{duplex} only
+exist if VIRTIO_NET_F_SPEED_DUPLEX is set.
+
+\field{speed} is the device speed, in units of 1MByte, 0 to
+0x7FFFF. Driver MUST also treat any
+other value as representing an unknown duplex state.
+
+\field{duplex} has the values of 0x00 for full duplex, 0x01 for
+half duplex and 0xff for unknown. Driver MUST also treat any
+other value as representing an unknown duplex state.
+
+Neither \field{speed} not \field{duplex} changes as long as
+VIRTIO_NET_S_LINK_UP is set.
+
 \begin{lstlisting}
 struct virtio_net_config {
         u8 mac[6];
         le16 status;
         le16 max_virtqueue_pairs;
         le16 mtu;
+        le32 speed;
+        u8 duplex;
+
 };
 \end{lstlisting}
 
@@ -2985,6 +3002,10 @@ \subsection{Device configuration layout}\label{sec:Device Types / Network Device
 If the driver negotiates the VIRTIO_NET_F_STANDBY feature, the device MAY act
 as a standby device for a primary device with the same MAC address.
 
+Device MUST NOT change the \field{speed} and \field{duplex}
+fields as long as VIRTIO_NET_S_LINK_UP is set in the
+\field{status}.
+
 \drivernormative{\subsubsection}{Device configuration layout}{Device Types / Network Device / Device configuration layout}
 
 A driver SHOULD negotiate VIRTIO_NET_F_MAC if the device offers it.
@@ -3009,6 +3030,10 @@ \subsection{Device configuration layout}\label{sec:Device Types / Network Device
 
 A driver SHOULD negotiate the VIRTIO_NET_F_STANDBY feature if the device offers it.
 
+A driver MUST treat a value of \field{speed} above
+0x000000007fffffff as well as a value of \field{duplex} not
+matching 0x0 or 0x1 as an unknown value.
+
 \subsubsection{Legacy Interface: Device configuration layout}\label{sec:Device Types / Network Device / Device configuration layout / Legacy Interface: Device configuration layout}
 \label{sec:Device Types / Block Device / Feature bits / Device configuration layout / Legacy Interface: Device configuration layout}
 When using the legacy interface, transitional devices and drivers
-- 
MST