ws-rx message
[Date Prev]
| [Thread Prev]
| [Thread Next]
| [Date Next]
--
[Date Index]
| [Thread Index]
| [List Home]
Subject: Re: [ws-rx] Proposed resolution for I083 - fault messages for terminatesequence
- From: Doug Davis <dug@us.ibm.com>
- To: ws-rx@lists.oasis-open.org
- Date: Wed, 18 Jan 2006 17:28:07 -0500
+1
-Doug
Tom Rutt <tom@coastin.com>
01/18/2006 05:20 PM
|
To
| wsrx <ws-rx@lists.oasis-open.org>
|
cc
|
|
Subject
| [ws-rx] Proposed resolution
for I083 - fault messages for terminate sequence |
|
Based on the discussion at the Jan 12 meeting, I propose
we close isue
I083 by adding a clarification that "unknown Sequence" is sent
for both
cases cited in the issue.
Detailed Proposal:
Line 614 of Candidate CD II draft:
Change:
“
UnknownSequence is a fault generated by endpoints when messages carrying
RM
header blocks targeted at unrecognized sequences are detected, these
faults are
also treated as defined in WS-Addressing.
“
To
“
UnknownSequence is a fault generated by endpoints when messages carrying
RM
header blocks targeted at unrecognized or terminated sequences are
detected, these faults are
also treated as defined in WS-Addressing.
“
Line 719 of Canditate CD II draft
Change:
“
This fault is sent by either the RM Source or the RM Destination in
response to a message
containing an unknown sequence identifier.
“
To:
“
This fault is sent by either the RM Source or the RM Destination in
response to a message
containing an unknown or terminated sequence identifier.
“
--
----------------------------------------------------
Tom Rutt
email: tom@coastin.com; trutt@us.fujitsu.com
Tel: +1 732 801 5744 Fax: +1 732 774
5133
[Date Prev]
| [Thread Prev]
| [Thread Next]
| [Date Next]
--
[Date Index]
| [Thread Index]
| [List Home]