Issue withdrawn due to incorporation if
issue 111 text in June 26 version of WD 15
Thanks
-bob
From: Doug Davis
[mailto:dug@us.ibm.com]
Sent: Monday, June 26, 2006 5:14
PM
To: ws-rx@lists.oasis-open.org
Subject: RE: [ws-rx] [NEW ISSUE]
Rollover underspecified, state of sequence is unclear
I have no idea what happened but issue 111 doesn't show
up in the change log so, as you noted, it was never applied.
I've
now do so - please see the latest WD and see if we still need your issue.
-Doug
"Bob Freund-Hitachi" <bob.freund@hitachisoftware.com>
06/26/2006 03:48 PM
|
To
|
Doug Davis/Raleigh/IBM@IBMUS,
<ws-rx@lists.oasis-open.org>
|
cc
|
|
Subject
|
RE: [ws-rx] [NEW ISSUE] Rollover
underspecified, state of sequence is unclear
|
|
I think we did, but I can’t find it in WD
15.
I think that we decided that it might close the sequence but
that is not in the text unless you know where it is.
Thanks
-bob
From: Doug Davis
[mailto:dug@us.ibm.com]
Sent: Monday, June 26, 2006 12:25 PM
To: ws-rx@lists.oasis-open.org
Subject: Re: [ws-rx] [NEW ISSUE] Rollover underspecified, state of
sequence is unclear
Bob,
if a MsgNumRollover fault is generated I don't think the RMD should
necessarily terminate the sequence.There may be other messages, with lower
numbers, that could still be received and processed successfully. Didn't
we discuss this already - it sounds familiar.
-Doug
"Bob Freund-Hitachi" <bob.freund@hitachisoftware.com>
06/26/2006 11:33 AM
|
To
|
"[WS-RX]"
<ws-rx@lists.oasis-open.org>
|
cc
|
|
Subject
|
[ws-rx] [NEW ISSUE] Rollover underspecified,
state of sequence is unclear
|
|
Description
WD 15 lines 564-570 state that if the internal limitation for MessageNumber is
exceeded by either RMS or RMS, then a MessageNumberRollover fault is generated.
Section 4.5 which describes the fault provides no further information
Justification
Possibility for protocol lockup or non-interoperable behavior
Target: core
Proposal:
Insert after line 570:
Generation or receipt of a MessageNumberRollover fault MUST immediately
terminate the sequence
Insert in section 4.5
Sent by: RMS or RMD
Condition: message numbers for a Sequence have been exhausted
Action upon Generation or receipt: The Sequence is terminated immediately.