RE: DOCBOOK-APPS: Parts and Numbering

[Stephan Wiesner <stephan@stephan-wiesner.de>]

Good morning Bob and thanks. That worked fine.

Stephan

> -----Original Message-----
> From: bobs@caldera.com [mailto:bobs@caldera.com] 
> Sent: Sonntag, 15. Dezember 2002 19:44
> To: Stephan Wiesner; docbook-apps@lists.oasis-open.org
> Subject: Re: DOCBOOK-APPS: Parts and Numbering
> 
> 
> On Sun, Dec 15, 2002 at 11:54:49AM +0100, Stephan Wiesner wrote:
> > Hi list,
> > I have a large document with three parts. These contain chapters, 
> > which contain sections.
> > 
> > The numbering for the chapters, figures, tables, etc. Start 
> at 1 for 
> > each part.
> > 
> > When I reference (xref) a table, I get a textual 
> representation (see 
> > Table 1.4). In the PDF, this is linked with the 
> corresponding table. 
> > In printed form, however, the reader has no way to know in 
> which part 
> > this table can be found. This is not acceptable for me.
> > 
> > The question is: Is there an easy way to make the numbering 
> increase 
> > over the parts?
> > 
> > XSL version of the style, using FOP
> 
> The parameter 'label.from.part' controls this behavior.
> By default it is zero, which should number the chapters 
> consecutively through the book.  Do you have a customization 
> layer that sets that parameter to nonzero? 
> 
> -- 
> 
> Bob Stayton                                 400 Encinal Street
> Publications Architect                      Santa Cruz, CA  95060
> Technical Publications                      voice: (831) 427-7796
> The SCO Group                               fax:   (831) 429-1887
>                                             email: bobs@sco.com
>