RE: [sca-assembly] Complete Conformance version of Assembly Specificatio

Hi Mike,

I’ve not had enough time yet to fully digest the full extent of the changes as there are quite a few! Hopefully, I will get through some more of the updates before the call today.

Whilst reading through the Conformance Items in Appendix D, I noticed the following editorial issues:

· The following Conformance IDs contain the text in the Conformance ID column

ASM50028

ASM50033

ASM80001

ASM12010

· There is a bullet numbering issues in ASM12013, the table uses the numbers 3, 4 and 5 whereas the source text in the specification uses 1 and 2

Thanks,

Mark

From: Mike Edwards [mailto:mike_edwards@uk.ibm.com]
Sent: 27 October 2008 10:42
To: OASIS Assembly
Subject: [sca-assembly] Complete Conformance version of Assembly Specification

Folks,

Here is a complete version of the "conformance" version of the Assembly specification:

I'd like to make this into "CD01-Rev3", so I'd appreciate any comments or suggested changes
by tomorrow's Assembly TC call.

Note that a couple of sections have been deliberately missed out from the conformance work -
those sections are ones that I am aware are due for significant rework caused by Issue resolutions
in the pipeline - and I decided not to waste time and effort on these. We can do the conformance
work on those sections when the resolutions are edited into a future version.

Yours, Mike.

Strategist - Emerging Technologies, SCA & SDO.
Co Chair OASIS SCA Assembly TC.
IBM Hursley Park, Mail Point 146, Winchester, SO21 2JN, Great Britain.
Phone & FAX: +44-1962-818014 Mobile: +44-7802-467431
Email: mike_edwards@uk.ibm.com

Unless stated otherwise above:
IBM United Kingdom Limited - Registered in England and Wales with number 741598.
Registered office: PO Box 41, North Harbour, Portsmouth, Hampshire PO6 3AU

sca-assembly message